Note - we're booked up for most of November - pop us an email for any enquiries or to schedule an appointment in store.
In cooperation with KTC Cooling we have developed an extension set for watercooling solutions. With the analog sensor hub you can connect very thin analog sensors and Push-in water temperature probes. With the T-Flow flowmeter you can automatically monitor liquid speed and you can define temperature and liquid speed limits, which lead to an emergency switch-off.
T-Flow flowmeter
With the T-Flow we offer a flowmeter with a good measuring range at low pressure losses. You can connect up to 2 flowmeters. To improve measurement results you can choose in the T-Balancer software different measurement ranges. For the T-Flow the range "4sec" applies.
modell: plastic, white
jet: 3.3 mm
impulse per litre: 509 (with software calibratible)
maximum flow: 6 l/min
magnets: Ceramic Sr Fe O
temperature range: -10?C to +65?C
winding G1/4"
connection: 3Pin-Molex (female)
Water temperature probe Push-In
This water temperature probe is a Push-In system. You can push it into a t-piece or into the compensation tank. A sensitive analog sensor is embedded in the plug. Up to 6 water temp probes can be connected to the T-Balancer.
The plug is made of either nickel, bronze or aluminium to ensure an optimal heat conductivity.
The sensor has a 30cm cable.
Push-In T-piece
Push-In T-piece for the implementation of a Push-in water temp probe.
Compatible: polyurethan-soft (PUR-W), Polyurethan (PUR)